多项选择题
The maximum number of routers per OSPF area typically depends on which three factors?（）
A. the kind of OSPF areas being implemented
B. the number of external LSAs in the network
C. the number of DRs and BDRs in the areas
D. the number of virtual links in the areas
E. how well the areas can be summarized
F. the use of LSA filters
相关考题
-
单项选择题
When an OSPF design is planned, which implementation can help a router not have memory resource issues?（）
A. Have a backbone area (area 0) with 40 routers and use default routes to reach external destinations
B. Have a backbo ne area (area 0) with 4 routers and 30,000 external routes injected into OSPF
C. Have less OSPF areas to reduce the need for interarea route summarizations
D. Have multiple OSPF processes on each OSPF router. Example, router ospf 1, router ospf 2 -
单项选择题
You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router 172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds. What could be the cause of this problem?（）
A. OSPF authentication errors between some of the routers
B. Two routers have the same OSPF router ID
C. Issues with mistuned OSPF timers
D. OSPF LSA pacing issues between some of the routers
E. OSPF neighbor adjacency problems between some of the routers -
单项选择题
Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?（）
A. All OSPF implementations must have at le ast one interface in area 0.
B. You are attempting to run in the broadcast mode over an NBMA interface.
C. Both routers are configured to function as a BDR; therefore, there is no DR router.
D. Someone has changed the OSPF router ID; therefore you must clear the OSPF process.
E. The OSPF priority is set to 0 on both routers; therefore neither can become the DR.
